Precautions for color steel equipment of floor deck machine

Steel-concrete composite structures are often used in the high-rise steel structure design of the color steel equipment of the floor decking machine. In high-rise buildings with high seismic intensity or very irregular high-rise buildings, unfavorable seismic center pipes and outer frames should not be selected solely for economic reasons. It is recommended to choose the surrounding giant src column, whose center is the structural system supporting the frame. In my country, more than half of such managers are the former. Opposing earthquakes is not very good. In a light steel plant, when the suspended load or moving load is large, you can consider giving up the mast and adopting the grille. In areas with heavy snow pressure, the roof curve should facilitate the sliding of snow, while areas with heavy rainfall are similar to the idea. When the building allows it, it is more economical to arrange the brackets in the frame than to connect only simple nodes.

In buildings with a wide range of roof coverings, the suspension cable or cable membrane structure system, which is the main tension component, can be selected. Those who do not understand the structure and performance of the color steel equipment of the floor deck machine and the operating procedures of the floor machine are not allowed to start the machine. It is strictly forbidden to stop working beyond the small closing height, that is, the small distance between the bottom surface of the upper sliding box and the working surface is 290 mm. It is required to increase the height behind the upper and lower molds. The thickness of the upper and lower pads plus the thickness of the tiles shall not exceed 290 mm. The design should be stopped according to this requirement to avoid machine tool accidents. Always pay attention to the oil height of the sliding box and both sides of the machine. The equipment should be wiped frequently and kept clean, without turbid water.